Operating The Induction Hob - Panasonic KY-R647EL Operating And Installation Instructions

Using the Induction Hob
Before use
•
Read this guide, taking special note of the 'Safety Precautions' section.
•
Remove any protective film that may still be on your Induction Hob.
Using the Touch Controls
•
The controls respond to touch, so you don't need to apply any
pressure.
•
Use the ball of your finger, not its tip.
•
You will hear a beep each time a touch is registered.
•
Make sure the controls are always clean, dry, and that there is
no object (e.g. a utensil or a cloth) covering them. Even a thin
film of water may make the controls difficult to operate.
Start cooking
After connecting the Induction Hob to the power supply, a beep will sound once.
1. Touch
entered the state of standby mode.
2. Place a suitable cookware on the cooking zone that you wish to use.
•
Make sure the bottom of the cookware and the surface of the cooking zone are
clean and dry.
3. Select a heat setting by touching the
you require. (Heating should be within 1-9)
•
If you don't choose a heat setting within 1 minute, the Induction Hob will
automatically switch off. You will need to start again from step 1.
•
You can modify the heat setting at any time during cooking.
■
Note:
If the display flashes on the display, it means one of the following:
•
You have not placed a cookware on the correct cooking zone.
•
The cookware you are using is not suitable for induction cooking.
•
The cookware is too small or not properly centered on the cooking zone.
No heating takes place unless there is a suitable cookware on the correct cooking zone.
The display will automatically turn off after 1 minute if no suitable cookware is placed on it.
EN-8

Operating the Induction Hob

, all displays show or , indicating that the Induction Hob has
or control on the cooking zone which
Suitable Unsuitable