Intermec ColorCoder V4 Service Manual page 204

6.4 Head Shading, cont'd.
6.4:B Procedure to Make HS Data,
cont'd.
Intermec ColorCoder V4 – Service Manual Ed. 1
Creating new HS data for C, M, and Y, cont'd.
8. Click "Test print". When the message to confirm "Performing
test chart" appears on the display, execute print by clicking
"Execute".
9. When "Printing is finished" appears on the display, finish
printing by clicking "OK". Make sure efficiency of HS with
output test chart. If re-reading of the data is required, carry out
from "Scan test chart".
Note:
When re-executing "Scan test chart", use the test chart printed out in the
item "Output test chart". Never use the test chart printed out by "Test
print".
10. Click "Confirm HS file" in HS utility menu.
11. Input final 5 digits of serial number of the printer on which HS
data is created in "Confirm hs file". The serial number is to
distinguish among plural computers to which a host computer
is connected.
12. Click "OK".
13. "Insert the disk for hs" appears on the display, insert the floppy
disk for HS data and click "OK".
Chapter 6 Troubleshooting
Figure 6-24
Figure 6-25
203