Bowflex TreadClimber TC100 Service Manual page 86

16. Install the IGUS ("hat" shaped yellow) bushings into the pivot arms.
17. Install the metal spacers/ washers into the yellow bushings.
18. Add the yellow washers to both sides of the Center Block as the bolt is
installed. Tighten only until the nut has bottomed out on the metal spacers/
washers.
Note: Do not overtighten. Excessive tightening will cause the metal
spacer to crack.
19. Remaining assembly is the reverse procedure.
Wrap the new Drive Belt around the Motor Pulley. Start the Drive Belt on
the Drive Pulley and roll it in a clockwise motion. Be sure the Belt does not
come off of the Motor Pulley.
Keep fingers out of any pinch opportunities when turning the
Pulleys.
Roll the Drive Pulley clockwise until the Drive Belt is fully installed.
Continue to roll the Belt forward while adding side pressure with fingers to
align as necessary.
20. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
86