Anti-Rush Current Pcb; Before Removing Anti-Rush Current Pcb; Removing Anti-Rush Current Pcb - Canon imageRUNNER 5065 series Service Manual

Chapter 10
1) Detach the mount cover [2].
- 5 screws [1]
[1]
[1]
2) Open the 2 wire saddles [1].
3) Disconnect the 7 connectors [2].
4) Remove the fixing heater power supply unit [4].
- 3 screws [3]
[4] [3]
5) Detach the fixing heater power supply unit cover [2].
- 14 screws [1]
[1]
6) Remove the 2 reuse bands [2].
- 2 connectors [1]
7) Remove the fixing heater power supply PCB [4].
- 6 screws [3]
10-24
[1]
[1]
[2]
F-10-80
[2] [3] [2]
[2] [1]
F-10-81
[1] [1]
[1] [2]
F-10-82
[2] [3] [1]
[2] [3]

10.5.16 Anti-Rush Current PCB

10.5.16.1 Before Removing Anti-Rush Current PCB

iR5065 / iR 5055 / iR5075 / / /
1) Detach the rear cover (upper). (page 10-11)Reference[Removing the
Rear Cover (Upper)]

10.5.16.2 Removing Anti-Rush Current PCB

iR5065 / iR 5055 / iR5075 / / /
1) Disconnect all connectors on the DC controller PCB.
2) Remove the DC controller PCB mount [2] and turn it over.
- 14 wire saddles (free the harness)
- 1 edge saddle (free the harness)
- 1 reuse band
- 8 screws [1] (free the grounding wire)
[1] [2]
[1]
3) Remove the anti-rush current PCB [4].
- 3 connectors [1]
- 3 PCB supports [3]
- 1 screw [2]
[3]
[4] [3]
F-10-83
[1]
F-10-84
0015-5135
0015-5136