Duplex Unit Pcb; Before Removing The Duplex Unit Pcb; Removing The Duplex Unit Pcb; Control Panel - Canon imageRUNNER 5065 series Service Manual

[1]
[2]
4) Disconnect the connector [1] of the auxiliary power and connect the
jumper connector [2].
[1]
5) Once the main power is turned on, the following message is displayed on
the control panel.
"Time for maintenance work.
The capacitor needs checking. Please call the service personnel.
You can continue to use the machine, however, the operational speed
during printing may be slower than usual"
6) Once pressing "Close" button, a message, "The capacitor needs checking
(Please call the service personnel)", is displayed at the bottom on the

control panel.

This is a temporary measure. Be sure to replace with the new one once you
receive the Power Accumulating Unit.
This step enables direct power supply from the auxiliary power to the
reader/DADF. Therefore, the speed of continuous print after power-on (for
approx. 15 min) becomes shorter.

10.5.10 Duplex Unit PCB

10.5.10.1 Before Removing the Duplex unit PCB

iR5065 / iR 5055 / iR5075 / / /
1) Detach the duplexing
12)Reference[Removing the Duplexing Feed Front Cover]
2) Remove the duplex feeding unit. (page 8-44)Reference[Removing the
Duplex Feeding Unit]

10.5.10.2 Removing the Duplex Unit PCB

iR5065 / iR 5055 / iR5075 / / /
1) Remove the duplex unit PCB [3].
- 4 screws [1]
- 6 connectors [2]
[1]
[1]
[1]
[1]
F-10-65
[2]
F-10-66
T-10-19
feed front cover. (page
[1]
[2]
10.5.11 Control Panel

10.5.11.1 Before Removing Control Panel

iR5065 / iR 5055 / iR5075 / / /
1) Detach the right cover (upper). (page 10-10)Reference[Removing the
Right Cover (Upper)]
2) Detach the reader right cover. (page 10-15)Reference[Removing the
Reader Right Cover]
3) Detach the left cover (upper). (page 10-10)Reference[Removing the
Left Cover (Upper)]
4) Detach the reader left cover. (page 10-15)Reference[Removing the
Reader Left Cover]
5) Detach the reader front cover. (page 10-15)Reference[Detaching the
Reader Front Cover]

10.5.11.2 Removing Control Panel

iR5065 / iR 5055 / iR5075 / / /
1) Open the hopper front cover.
2) Remove the 5 screws [1] at right, left, rear of the control panel [2].
0015-9413
10-
0015-9412
[2]
[1] [3] [1]
F-10-67
[2] [1]
F-10-68
[1] [2]
F-10-69
Chapter 10
[1]
[2]
0015-6564
0015-5118
10-21