SATO CL608e Operator's Manual page 58

REPRINT W/FEED
YES
FORWARD/BACKFEED
DISTANCE
FORWARD/BACKFEED
DISTANCE
EURO CODE
SELECT LANGUAGE
ENGLISH
PRIORITY SETTING
LCD
SATO CL Series "e" Printers
This selection specifies whether or not the printer will print the
last printed label stored in memory when the FEED key is
NO
pressed in the Normal Online mode.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will reprint the last label when
the FEED key is pressed when the printer is Online. If the
printer is Offline, pressing the FEED key will feed a blank
label. If No is selected, the display will advance to the
mode display.
This dsiplay will only appear when Backfeed is enabled
(DSW3-4 = OFF). The maximum backfeed distance is 255
DEFAULT
mm.
1. Use the LINE key to select either the Default or the
Distance selection. If Default is selected, the display steps
to the Web acceleration selection.
2. If Manual setting is selected, use the LINE key to advance
the distance to the desired setting. Each time the LINE
XXXmm
key is pressed, the Distance will advance 1 mm. The
maximum distance is 255 mm.
3. Once the desired distance is set, press the FEED key to
accept the setting and step to the next display.
This selection allows the user to specify the dexadecimal code
for the character which is replaced with the Euro Character.
D5
The default is D5
1. The cursor should be positioned over the first digit
selection. Use the LINE key to step to the desired setting.
2. Press the FEED key to advance the cursor to the second
digit of the desired hexacecimal code.
3. Press the LINE key to step to the desired setting.
4. When the setting is correct, press the FEED key to accept
the setting and step to the next display.
This selection allows the user to select the character set used
by the printer. The selections are English, French, German,
Spanish, Italian and Portuguese.
1. Press the LINE key to advance to the desired languarge
setting.
2. When the setting is correct, press the FEED key to accept
the setting and step to the next display.
This selection allows the user to assign a priority for Print
Darkenss, Print Speed and Print Offset.
COMMAND
1. Use the LINE key to step to the desired priority. If LCD is
selected, the setting established via the LCD
display/menu system will be used for an incoming label
job, regardless of any different command settings. If
Command is selected, any commands in the label job will
take precedence and be used for printing the job and the
LCD Display will reflect the new setting.
2. Once the desired setting is selected, press the FEED key to
accept the setting and step to the next display.
PN 9001074 Rev. B
Section 3. Configuration
.
H
Page 3-21