SATO CL608e Operator's Manual page 54

MEMORY->CARDCOPY
ALL
COPY START
YES
MEMORY->CARD
COPY
COPYING
MEMORY->CARD
COPY
COMPLETED
CARD COPY/FORMAT
XXXXXXX ERROR
CARD->MEMORYCOPY
PROGRAM
COPY START
YES
CARD->MEMORY
COPY
COPYING
CARD->MEMORYCOPY
COMPLETED
CARD COPY/FORMAT
XXXXXXX ERROR
MEMORY->CARDCOPY
PROGRAM
SATO CL Series "e" Printers
This selection allows you to copy the entire contents of the
optional Expanded Memory to the PCMCIA Memory card
<XMB> Y/N
installed in the Memory Card slot on the rear of the printer.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode.
If No is selected, the display will advance to the Card to
Memory Copy All mode.
2. Confirm your selection by stepping the underline cursor to
the Yes selection. If you select No, the display will return
NO
to the previous selection.
3. Press the FEED key to accept the selection. If Yes was
selected the copy process will start
4. Once the copy process is completed, press the FEED key
to step the display.
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error
No Card Error
Mem Full Error
This selection allows the user to copy printer firmware from
the PCMCIA Memory Card to the printer.
Y/N
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode.
If No is selected, the display will advance to the mode
display.
2. Confirm your selection by stepping the underline cursor to
the Yes selection. If you select No, the display will return
NO
to the previous selection.
3. Press the FEED key to accept the selection. If Yes was
selected the copy process will start
4. Once the copy process is completed, press the FEED key
to step the display.
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error
No Card Error
Mem Full Error
This selection allows the user to copy the current firmware
installed in the printer to a PCMCIA Memory Card.
Y/N
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode.
If No is selected, the display will advance to the mode
display.
PN 9001074 Rev. B
Section 3. Configuration
Indicates a Read/Write error occured
Indicates no card was regognized
Indicates that there is insufficient
memory available.
Indicates a Read/Write error occured
Indicates no card was regognized
Indicates that there is insufficient
memory available.
Page 3-17