SATO CL608e Operator's Manual page 41

Section 3. Configuration
Backfeed Sequence (DSW3-1). Backfeed is used to correctly position the label for
application and then retract the next label to the proper print position. This operation
can be performed immediately after a label is printed and used, or immediately prior
to the printing of the next label.
DSW3-1
Off
Off
On
On
Label Sensor Selection (DSW3-3). Enables or disables the Label Sensor. If the
Sensor is enabled, it will detect the edge of the label and position it automatically. If
it is disabled, the positioning must be under software control using Line Feed
commands.
DSW3-3
Back-Feed Selection (DSW3-4). When Back-Feed is enabled, the printer will
position the last printed label for dispensing and retract it before printing the next
label. The amount of backfeed offset is adjustable .
DSW3-4
External Signal Interface. See Section 6: Interface Specifications for information
on the External Signals.
EXT Print Start Signal Selection (DSW3-5). Allows an external device to
initiate a label print for synchronization with the applicator. See Section 6: Interface
Specifications for a description of the signal level and requirements When DSW3-5 is
On, the unit is in the Continuous print mode, Backfeed is disabled and External
Signals are ignored.
DSW3-5
Off
On
Page 3-4
DSW3-2 SETTING
Off Continuous
On Tear-Off
Off Cutter
On Dispenser
SETTING
Off Sensor Used
On Not Used
SETTING
Off Enabled
On Disabled
SETTING
Enabled
Disabled
PN 9001074 Rev. B
DSW3
ON
OFF
1 2 3 4 5
DSW3
ON
OFF
1 2 3 4
DSW3
ON
OFF
1 2 3 4
DSW3
ON
OFF
1 2 3 4 5
SATO CL Series "e" Printers
6 7 8
5 6 7 8
5 6 7 8
6 7 8