Input Source Selection (Rgb Scart 21-Pin) - Sanyo PLC-XE50 Owner's Manual

Input Source Selection (RGB Scart 21-pin)

Direct Operation
Press the COMPUTER button on the remote control to
select Computer 1.
Before using the COMPUTER button, select the correct
input source through Menu operation as described below.
Menu Operation
1
Use the MENU button to display the On-Screen Menu.
Press the Point buttons to move the red frame
7 8
pointer to the Input Menu icon.
2
Use the Point buttons to move the red arrow
ed
pointer to Computer 1 and then press the SELECT
button.
3
After the Source Select Menu appeared for Computer
1, move the pointer to RGB (Scart) and then press the
SELECT button.
When the input source is coming from
RGB (Scart)
video equipment connected to the
COMPUTER IN 1 terminal with a Scart-VGA
Cable (not supplied), select RGB (Scart).
✔Note:
• Computer 2 is not displayed when the COMPUTER IN 2/
MONITOR OUT terminal is set as Monitor out (p.48).
• Computer 2 (COMPUTER IN 2/MONITOR OUT) can
accept only RGB signal.
• When the Input Search function is set On1 or On2, the
input signal will be searched automatically (p.48)
Remote Control
COMPUTER button
/
COMPUTER button
*See Note at the bottom of this page.
Input Menu icon
Input Menu
Move the pointer (red arrow)
to Computer 1 and press the
SELECT button.
Computer
1
Source Select Menu
Move the pointer to RGB (Scart)
and press the SELECT button.
Video Input
Computer 1
Computer *