Setting
Logo (Logo and Logo PIN code lock settings)
This function allows you to customize the screen logo with
Logo select, Capture, and Logo PIN code lock functions.
✔Note:
• When "On" is selected in Logo PIN code lock function,
Logo select and Capture functions cannot be selected.
Logo select
This function decides the start-up display as follows:
User.........The image you captured
Default......The factory-set logo
Off............Countdown only
Capture
This function enables you to capture the image being
projected and use it for a start-up display or interval of
presentations.
After capturing the projected image, go to the Logo
select function and set it to "User. " Then the captured
image is displayed when the projector is turned on next
time or the NO SHOW button is pressed (p 25).
To capture the image, select "Yes. " To cancel the Capture
function, select "No. "
✔Note:
• Before capturing an image, select "Standard" in the
Image Select Menu to capture a proper image (pp.31-
32, 39-40).
• A signal from a computer can be captured up to
XGA(1024x 768). A signal from video equipment can
be captured except for 720p, 1035i, and 1080i.
• When you capture the image that has been adjusted
by the Keystone function, the adjusted data is
automatically reset and the projector captures an
image without keystone adjustment.
• When the Logo PIN code lock function is "On, "
Capture menu cannot be selected.
• When you start to capture a new image, the
previously stored image is cleared even if you cancel
the capturing.
• User cannot be selected when the image is not
captured.
Logo select
Capture
Select "Yes" to capture
the projected image.
Select "Yes" to
stop capturing.