16 KTM POWERPACK, BATTERY CHARGER
16.8
110
C00769-10
C00854-01
C00769-11
Changing charging socket protection cap
Warning
Risk of injury There is a risk of electric shock when working on high-voltage components.
Work on high-voltage components requires special training, qualifications and tools.
–
Have all work that is not described and explained performed by trained KTM mechanics only.
–
Do not open the electric motor or the lithium-ion battery (KTM PowerPack).
Info
If the safety cord or seal ring is damaged or torn off, the charging socket protection cap must be replaced.
–
Switch on the battery charger using switch
Charging starts automatically. The status indicator flashes
during the charging process.
–
Monitor the charging level of the KTM PowerPack using the
LEDs.
LED 1: 20%
LED 2: 40 %
After the charging process is completed to a level of 50%,
LEDs 1 and 2 light up and the status indicator goes out.
–
Switch off the battery charger using switch
After several seconds, all LEDs on the battery charger go
out.
–
Disconnect the battery charger power plug from the mains con-
nection.
–
Disconnect the charging cable from the KTM PowerPack.
Guideline
Pull on the structured part of the connector. Do not pull on
the cable.
–
Check the seal on the charging socket protection cap.
»
If the seal is dirty:
–
Clean the seal without using water or compressed air.
»
If the seal is damaged or worn:
–
Change the seal.
–
Mount the charging socket protection cap.
3
.
4
.