Table of Contents
Advertisement
10.3 Replacing an I/O Module
Warning
Warning
Caution
To remove an individual module from the station, all modules to the right of it and the termination kit
must be moved by approximately 5 cm (2 in).
➢ To replace an I/O module
1. Unfasten the mounting screw on the right-hand end bracket.
2. Slide the end bracket and end plate approximately 5 cm (2 in) to the right or remove both
parts from the DIN rail.
3. Open the release lever on the module furthest to the right.
GFK-2958E
Explosion Risk - Prior to starting work, ensure that there is not a
potentially explosive atmosphere.
Dangerous contact voltage - Prior to removing modules, the RSTi-EP
station must be completely de-energised (supply of the field bus
network adapter and all external feed-in). Ensure that the place of
installation (switch cabinet and so forth) has been disconnected from
the power supply.
The components in the RSTi-EP series can be destroyed by electrostatic
discharge. Ensure that personnel and work equipment are adequately
grounded.
RSTi-EP User Manual
Chapter 10 Replacing Components
389
Advertisement
Table of Contents
