Setting Up The Front Panel Button - Extron electronics MLC 104 IP Plus Series User Manual

Setting Up the Front Panel Button

This section describes a procedure for setting up monitoring of audio and video muting
status on the MLC, the
other functions that you may want to set up. This example assumes that you performed the
prerequisite setup steps. Ensure that the Global Configurator project is open and the MLC is
selected within the project.
1. Click on the Front Panel tab.
2. Click the Input 4 button.
3. If desired, type in text for the on-screen button label and the tool tip (text that appears
when the mouse pointer hovers over that button).
4.
In the Button Modes panel, select Toggle. This changes sets the button from single
switch mode to toggle mode, which allows you to configure the button for two sets of
presses and releases instead of the default of one press and release.
5. In the Driver tab within the Button Operations panel, double-click the name of
the projector. A list of available driver functions is displayed below the driver name.
6. Set the button press actions for projector AV mute.
a. Double-click Video Mute.
b. Click On.
c. Click the green arrow adjacent to the Release area or drag the command to the
Release area.
NOTE: Extron recommends that you always assign monitored functions to the
d. For Toggle, click 1 to associate the AV Mute On command with the first button
release.
example introduced on page 108. You can tailor this procedure to
button release for best results.
MLC 104 IP Plus Series • Special Applications 110