ZyXEL Communications LTE3202-M430 User Manual page 33

Table 12 Monitor > LTE modem status
LABEL
LAC
TAC
Cell ID
Service Type
Operation Band
RSSI
Register Status
Ecio
CS Attached Status
PS Attached Status
Roaming Status
IMSI
SMSC
MSISDN
RSRP
RSRQ
SINR
PLMN
MIMO
Support Band List
Chapter 5 Monitor
DESCRIPTION
This displays the 2-octet Location Area Code (LAC), which is used to identify a
location area within a PLMN.
This displays the Tracking Area Code (TAC), which is to identify a tracking area within
a PLMN.
This displays the ID of a cell at the physical layer.
This displays the type of the mobile network to which the LTE3202-M430 is
connecting.
This displays the network type and the frequency band used by the mobile network
to which the LTE3202-M430 is connecting.
This displays the received signal strength indicator (RSSI), that is, the received signal
strength in dBm.
This displays the packet switched network registration status.
This displays the ratio (in dB) of the received energy per chip and the interference
level.
This displays the Circuit Switched network registration status.
This displays the Packet switched Domain Attachment status.
This displays whether the LTE3202-M430 is connected to another service provider's
mobile network using roaming.
This displays the International Mobile Subscriber Identity (IMSI) stored in the SIM
(Subscriber Identity Module) card. The SIM card is installed in a mobile device and
used for authenticating a customer to the carrier network. IMSI is a unique 15-digit
number used to identify a user on a network.
This displays the number for Short Message Service Center (SMSC), which stores,
forwards and delivers SMS text message.
This displays the MSISDN (Mobile Subscriber ISDN) number, a phone number assigned
to a mobile subscriber to call a mobile device.
This displays the Reference Signal Receive Power (RSRP), which is the average
received power of all Resource Elements (RE) that carry cell-specific Reference
Signals (RS) within the specified bandwidth.
This displays the Reference Signal Received Quality (RSRQ), which is the ratio of RSRP
to the E-UTRA carrier RSSI and indicates the quality of the received reference signal.
This displays the Signal to Interference plus Noise Ratio (SINR). A negative value
means more noise than signal.
This displays the Public Land Mobile Network (PLMN) code of the mobile network.
This displays the MIMO (Multi-input Multi-output) technology supported by the
LTE3202-M430, such as 1T2R (1 Transmit and 2 Receive paths/antennas) or TM1-TM4
(Transmission Mode 4).
This displays the frequency bands that are supported by the LTE3202-M430.
LTE3202-M430 User's Guide
33