ZyXEL Communications LTE3202-M430 User Manual page 13

WPS allows you to quickly set up a wireless network with strong security, without having to configure
security settings manually. Each WPS connection works between two devices. Both devices must
support WPS (check each device's documentation to make sure).
Depending on the devices you have, you can either press a button (on the device itself, or in its
configuration utility) or enter a PIN (a unique Personal Identification Number that allows one device to
authenticate the other) in each of the two devices. When WPS is activated on a device, it has two
minutes to find another device that also has WPS activated. Then, the two devices connect and set up
a secure network by themselves.
You can use the WPS button on the rear panel of the LTE3202-M430 to activate WPS in order to quickly
set up a wireless network with strong security.
Press the WPS button for more than five seconds and release it. Press the WPS button on another WPS
enabled device within range of the LTE3202-M430.
Note: You must activate WPS in the LTE3202-M430 and in another wireless device within two
minutes of each other.
1.5.2.3 Reset the LTE3202-M430
If you forget your password or IP address, or you cannot access the Web Configurator, you will need to
use the physical Reset button to reload the factory-default configuration file. This means that you will
lose all configurations that you had previously saved, the password will be reset to 1234 and the IP
address will be reset to 192.168.1.1.
How to Use the Reset Button
Press the Reset button on the rear panel for two seconds to restart/reboot the LTE3202-M430.
1
Press the Reset button on the rear panel for more than five seconds to set the LTE3202-M430 back to its
2
factory default configurations.
Chapter 1 Introduction
LTE3202-M430 User's Guide
13