ZyXEL Communications LTE3202-M430 User Manual page 19

Table 4 Navigation Panel
MENU SUB-MENU
WLAN station
status
LTE modem status
Configuration
WAN network Cellular Network
PIN Settings
APN
Configuration
Network
Selection
Data Usage /
Statistics
Operating Mode Use this screen to select whether the LTE3202-M430 operates in router
Antenna
Selection
LAN network LAN IP
DHCP Server
DNS Settings
WLAN WiFi Settings
MAC Filter
WPS
Firewall DOS protection
ICMP Protection
ARP Protection
URL Filter
IPv4 Port Filter
IPv6 Port Filter
NAT IP/Port
Forwarding
DMZ
ALG
Pass through
Chapter 2 The Web Configurator
DESCRIPTION
Use this screen to view the wireless stations that are currently
associated to the LTE3202-M430's 2.4GHz wireless LAN.
Use this screen to view the detailed information about the LTE module,
cellular interface, and SIM card. You can also view the LTE connection
status.
Use this screen to specify the type of the mobile network to which the
LTE3202-M430 is connected, and how you want the LTE3202-M430 to
connect to an available mobile network.
Use this screen to enable PIN code authentication and enter the PIN
code.
Use this screen to configure user-defined connection profiles.
Use this screen to view available Public Land Mobile Networks (PLMNs)
and select a preferred network.
Use this screen to specify limiting amount of package data consumed
and view its statistics.
or bridge mode.
Use this screen to specify which antennas the LTE3202-M430 uses for
signal transmission.
Use this screen to configure LAN IP address and subnet mask.
Use this screen to enable the LTE5366's DHCP server, and assign IP
addresses to specific individual computers based on their MAC
addresses and to have DNS servers assigned by the DHCP server.
Use this screen to configure the DNS servers.
Use this screen to enable the wireless LAN and configure wireless LAN
and wireless security settings.
Use the MAC filter screen to allow or deny wireless stations based on
their MAC addresses from connecting to the LTE3202-M430.
Use this screen to use WPS to connect to a wireless device.
Use this screen to enable/disable DoS protection.
Use this screen to enable/disable PING requests in the LTE3202-M430
interfaces.
Use this screen to enable Address Resolution Protocol (ARP)
protection.
Use this screen to configure URL firewall rules.
Use this screen to create IPv4 firewall rules.
Use this screen to create IPv6 firewall rules.
Use this screen to configure servers behind the LTE3202-M430 and
forward incoming service requests to the server(s) on your local
network.
Use this screen to set the IP address of your network DMZ (if you have
one) for the LTE3202-M430.
Use this screen to enable or disable SIP (VoIP) ALG (Application Layer
Gateway) in the LTE3202-M430.
Use this screen to enable/disable the ALGs (Application Layer
Gateway) in the LTE3202-M430.
LTE3202-M430 User's Guide
19