Schwinn 170 Service Manual page 60

3. Loosen and remove the thin Nut from the Power Inlet (C)
on the outside of the Shroud.
4.
Pull the Power Inlet plug (C) out of the hole toward the
inside of the Shroud. Discard the old Power Inlet assembly.
5. Installation is the reverse procedure.
NOTICE: Do not crimp any cables. Be sure the Power
Inlet plug is seated evenly in the hole.
6. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
C
C
A
60
A
C