13. Reinstall the Mast, Console and Top Shroud. (Refer to
the "Replace the Shrouds" procedure.) Turn the power on.
Machine is on. Current is active. There is risk of electrical
shock.
14. Use the console to set the resistance to the highest
level. Unplug the machine.
Disconnect all power and allow to sit for 5 minutes.
15. Put the Brake Arm (K) back in position and connect the
Tension Spring (J) using the needlenose pliers.
Note: B efore fully attaching the Shrouds, remove the
cardboard from between the Brake Magnet (A)
and the Flywheel (B). Power up the machine to
verify that the Magnet Arm can move freely, and
that the Brake Magnet and Flywheel do not touch
at the maximum resistance level. If necessary,
refer to the "Set the Brake Tension" procedure.
16. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
50