Schwinn 170 Service Manual page 37

5. Remove the T-handle and washers that attach the
Handlebar to the Mast. Set them safely aside for reassembly.
NOTICE: Hold the Handlebar so that it does not fall.
6. Untie the string from the HR Cable. Remove the old
Handlebar and discard it.
7.
Put the replacement Handlebar in the bracket, adjust
the Handlebar to the desired angle, and install the T-handle
through the holes.
NOTICE: Do not crimp the cables.
8.
Tie the end of the string under the Handlebar Bracket to
the end of the HR cable. Carefully pull the cable through the
slot under the Handlebar Bracket to the top of the mast. Fully
tighten the T-handle to keep the Handlebar in position. Push
the cover into position on the Handlebar Bracket.
NOTICE: Do not crimp the cables. Do not let the cables
fall down in the Mast.
9.
Connect the cables to the back of the Console and
attach the Console to the Mast.
NOTICE: Do not crimp the cables.
10. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
37