Schwinn 170 Service Manual page 40

5. Remove the T-handle and washers that attach the
Handlebar to the Mast. Set them safely aside for reassembly.
NOTICE: Hold the Handlebar so that it does not fall.
6. Remove the Handlebar and set it safely aside for
reassembly.
7.
Bend the edges of the Top Shroud to disengage the
inside tabs from the Main Assembly, and slide the Mast
Gasket and Top Shroud up the Mast.
8. Remove the hardware (indicated) from the Mast. Gently
pull the Mast out and disconnect the cables. Set the hard-
ware, Mast Gasket and Top Shroud safely aside for reas-
sembly. Discard the old Mast.
NOTICE: Do not crimp the cables. This step may require
two people.
Note: Do not let the cables fall down inside the Frame.
9.
Install the replacement Console Mast, and the Mast
Gasket and Top Shroud on Main Assembly.
NOTICE: Make sure the Console Cable connector does
not fall into the Console Mast. Align the clips
on the cable connectors and make sure the
connectors lock. Do not crimp Console Cable.
Be sure the tabs on the Top Shroud snap into
the Main Assembly.
40
X2