Schwinn 170 Service Manual page 11

k. E NTR RSTN TST – (resistance test) Console Firmware will cause external servo motor to move up then back to
lowest setting, and show a RESISTANCE PASS. Monitor servo motor's activation during test. Press OK to exit.
l. ENTR INCLN TST – (incline test, 470 elliptical only.) Not used for 170/270 bikes. Allows lift motor adjustment:
move it up or down, or stop movement.
m. ENTR TACH TST – The tach rate will be displayed in the LCD. Displayed rate approximately equals (Input signal
in Hz) X 60 ÷ 8. Confirm that the displayed number matches the input value. Press OK to exit.
n. ENTR BLE TEST – (Bluetooth
communication is valid and programmed, BLE PASS is displayed. If not correct, BLE FAIL is displayed. Press OK
to exit.
o. ENTR RST CNSL – (console reset) The Console setup, user records and workout records are reset to defaults.
This option also resets MFG NVM (non-volatile memory). When complete, the Console displays POWER CYCLE
NOW. After the ''POWER CYCLE NOW" flashes in LCD, turn power off then back on. The Console returns to
initial state with date inputs prompt for users.
Note: After accessing the MFG Menu, if you use PAUSE/END to go back to the Power-Up Mode screen and then hold
down the PAUSE/END + Right buttons for Console Setup Mode, the Console will go directly to the MFG Menu instead. It
is necessary to power the machine off and on to restore the automatic path to Console Setup Mode.
test) Console Firmware will test communications with BLE module. If BLE module
®
11