Quick Start Wizard Via The Handheld Programmer_Note - Siemens SITRANS LR250 Operating Instructions Manual

6.2.3.1

Quick Start Wizard via the handheld programmer_note

Note
• A reset to factory defaults should be performed before running the Quick Start Wizard if
the device has been used in a previous application. See Master Reset (4.1.).
• The Quick Start wizard settings are inter-related and changes apply only after you select
Finish in the Wizard Complete step.
• Do not use the Quick Start wizard to modify parameters: see instead Parameter
reference (Page 143). (Perform customization for your application only after the Quick
Start has been completed).
• Default settings in the parameter tables are indicated with an asterisk (*).
1. Quick Start
1.1. Quick Start Wiz
● Point the programmer at the display from a maximum distance of 300 mm (1 ft), then press
RIGHT arrow
● Press RIGHT arrow
● Press RIGHT arrow
move directly to the next item.
● To change a setting, scroll to the desired item or key in a new value.
● After modifying a value, press RIGHT arrow
move to the next item.
● Quick Start settings take effect only after you select Finish.
SITRANS LR250 (FOUNDATION FIELDBUS)
Operating Instructions, 08/2014, A5E32221411-AC
to activate PROGRAM mode and open menu level 1.
twice to navigate to menu item 1.1 and open parameter view.
to open Edit mode or DOWN arrow
6.2 Operating via the handheld programmer
to accept default values and
to accept it and press DOWN arrow
Commissioning
to
65