Quick Start Wizard Via The Handheld Programmer - Siemens SITRANS LR560 Compact Operating Instructions

Commissioning
5.5 Commissioning via handheld programmer
5.5.4.1

Quick Start Wizard via the handheld programmer

Note
● A reset to factory defaults should be performed before running the Quick Start Wizard if
the device has been used in a previous application. See Quick Start Wizard via the local
display push buttons (Page 34).
● The Quick Start wizard settings are inter-related and changes apply only after you select
Finish in the Wizard Complete step.
● Do not use the Quick Start wizard to modify parameters. Instead refer to "Parameter
reference" in the full operating instructions. Perform customization for your application only
after the Quick Start has been completed.
Quick Start Wizard
1. Point the programmer at the display from a maximum distance of 300 mm (1 ft.), then press
RIGHT
2. Press RIGHT
3. Press RIGHT
directly to the next item.
4. To change a setting, scroll to the desired item or key in a new value.
5. After modifying a value, press RIGHT
next item.
6. At any time, you can press UP
Measurement mode.
QUICK START WIZ
SET UP COMMON APPS
EASILY
Vessel
Factory setting:
Setting range:
Purpose:
Description:
40
to activate PROGRAM mode and open menu level 1.
twice to navigate to menu item 1.1 and open parameter view.
to open Edit mode or DOWN
CANCEL
NEXT
STEEL
STEEL or CONCRETE
Select vessel construction material.
● Selecting either STEEL or CONCRETE does a functional reset; see
MASTER RESET.
● Selecting STEEL changes the setting for POSITION DETECT to Rising
Edge and for ALGORITHM to F.
● Selecting CONCRETE changes the setting for POSITION DETECT to
Rising Edge and for ALGORITHM to ALF.
to accept default values and move
to accept it and press DOWN
to go back, or LEFT
Compact Operating Instructions, 06/2018, A5E39693895-AA
to move to the
to cancel and return to
LR560