Power Supply Cable, 80°C Max., 25M (80Ft.), (A-Cb-Lt-Ps-25); Power Supply Cable, 80°C Max., 50M (160Ft.), (A-Cb-Lt-Ps-50); Ethernet Cable, 80°C Max., 7.5M (25Ft.), (A-Cb-Lt-M12-W08-07); Figure 12: Power Supply Cable 7.5M (25Ft.) With Related Plug-In Contact Assignment - Fluke TV43 User Manual

Figure 12: Power supply cable 7.5m (25ft.) with related plug-in contact assignment

7.1.2. Power supply cable, 80°C max., 25m (80ft.), (A-CB-LT-PS-25)
Please see under 7.1.1, Power supply cable, 80°C max., 7.5m (25ft.), (A-CB-LT-PS-07).
Just the supplied cable length differs and is 25m (80ft.) instead of 7.5m (25ft.).
7.1.3. Power supply cable, 80°C max., 50m (160ft.), (A-CB-LT-PS-50)
Please see under 7.1.1, Power supply cable, 80°C max., 7.5m (25ft.), (A-CB-LT-PS-07).
Just the supplied cable length differs and is 50m (160ft.) instead of 7.5m (25ft.).
7.1.4. Ethernet cable, 80°C max., 7.5m (25ft.), (A-CB-LT-M12-W08-07)
The Gigabit Ethernet cable comes with an eight-pin male M12 connector, assigned to the
cameras rear eight-socket female M12 connector. The corresponding end of the Gigabit
Ethernet cable is equipped with a general RJ45 snap-in connector. The standard cable is
about 7 mm (0.3 in) in outer diameter and is 7.5 m (25 ft) long. The cable withstands ambient
temperatures up to 80°C (176°F). In case of using PoE (Power over Ethernet) to supply the
imager with power, the needed power is injected over the existing 8 data wires.

Figure 13: Ethernet cable 7.5m (25ft.) with RJ45 and M12 connector

Thermal Imager Camera
Accessories
1
3
2
15