Table of Contents
Advertisement
ThermoView® Series
Users Manual
•
Place camera conduction plate on inside surface
•
of enclosure and slide the outer slide onto the
•
housing as shown.
•
Connect ground cable onto housing as
•
shown before closing housing.
•
Tighten rear cover 3x screws, then tighten
•
2x set screws on outer slide as shown.
Slide camera forward if needed and ensure that camera conduction plate contacts inside
surface of enclosure in order to ensure adequate thermal conductivity.
•
Install front Germanium window cover by tightening
3x screws then install sunshield as shown.
•
Tighten rear cable glands to create
•
seal around cables.
36
Germanium
window cover
Sunshield
Advertisement
Table of Contents
