Table of Contents
Advertisement
Figure 36: Dimensions and Footprint of Outdoor Enclosure (A-TV-ENC)
Installation
•
Locate 2x M4 screws on camera
•
Place conduction plate onto camera as shown, making sure to line up holes on camera with
hole and slot on the conduction plate.
•
Install 2x M4 screws and secure conduction plate onto camera.
•
Place housing internal rail onto conduction plate as shown.
•
Secure conduction plate to rail by installing 2x Screws (truss),
4x curved washers (2x per screw), and 2x flat washers.
Insert each screw half a turn past after contacting curved washer
and slide camera forward.
•
Secure ground cable to camera as shown (color of cable/ring terminals used for display
only), from camera to internal rail screw with tooth washer. Then install supplied ground
cable onto heater board for connection to enclosure.
•
Disassemble Ethernet cable connector by loosening nut as shown.
•
Remove cable from RJ45 jack by lifting tab, note wiring for reassembly.
•
Pass Ethernet cable through enclosure cable gland as shown and reassemble connector.
•
Insert power cable with isolated cable ends through cable gland on enclosure.
•
Using power and Ethernet cables that have been passed through cable glands on rear of
enclosure, install cables onto camera (turn on camera if needed).
Thermal Imager Camera
Accessories
35
Advertisement
Table of Contents
