Power Camera On - Fluke Ti40FT-20 User Manual

You may use the auxiliary AC power supply to connect the camera to
a working AC outlet until at least one of the batteries is charged.

Power Camera On

With a charged battery inserted, or AC power supply connected, press D as
shown in Figure 1-3. D lights up green, and the start-up screen appears after
approximately 10 seconds.
After powering on your camera, the camera requires a boot up and
warm up period of approximately 30 seconds in order to maintain a
crisp, clear, real-time image. Three minutes after powering on the
camera, the temperature measurement accuracy will be within the
specification requirements.
Note
Figure 1-2. Inserting the Battery
Note
Introduction
Power Camera On
1
eii002.eps
1-7