On-Imager Ac Power Socket; Optional 12 V Vehicle Charger; Turning The Imager On And Off - Fluke Ti32 User Manual

4. Remove smart batteries and unplug power supply when batteries are
fully charged.

On-Imager AC Power Socket

1. Plug the ac power supply into an ac wall outlet and connect dc output
to the Imager's ac power socket.
2. Charge until on-screen indicator shows "full".
3. Disconnect ac power supply when smart battery is fully charged.
Ensure the Imager is near room temperature before connecting it to
the charger. See the charging temperature specification. Do not
charge the Imager in hot or cold places. Charging in extreme
temperatures reduces the battery pack's ability to hold a charge
While the battery is charging, the battery icon appears as A while the
Imager is operating. With the Imager off, b appears in the display while
connected to the battery charger.
Keep the Imager attached to the charger until the battery condition icon
indicates a full charge. With the Imager off, the battery charge icon will have
four full bars. With the Imager on, turn the Imager off to view the battery
condition icon. Removing the Imager from the charger before a full charge is
indicated will deprive the battery of a full charge and thus shorten the run time

Optional 12 V Vehicle Charger

1. Plug the 12 V adapter accessory plug into the vehicle's 12 V
accessory socket and connect the output to the Imager's ac power
socket.
2. Charge until on-screen indicator shows "full".
3. Disconnect the 12 V adapter and Imager when smart battery is fully
charged.
To avoid damage to the Imager, remove it from the DC car
charger before starting or jump starting the vehicle.

Turning the Imager On and Off

To turn the Imager on or off, press the center softkey (a) for two seconds.
Turning the Imager On and Off
Note
W Caution
Thermal Imagers
5