Figure 3-12 Network Tab - ABB XSeries G4 6200 User Manual

4) Move to the IP Address parameter field, and type in the IP address that is
5) Close PCCU32.
6) Open the door to the unit, and locate the Reset button on the board. When
7) The user will need to reopen PCCU32, but do not connect.
8) From the PCCU32 toolbar, click the Setup icon. This will take the user to the
9) Within the System Setup dialog box, the user needs to select the TCP/IP
10) Move to the Network ID or IP parameter field, and type in the IP address
11) Click the Close button.
12) Reconnect to PCCU32, and move back into Entry mode. This establishes
Page 3–12
Figure 3–12 Network tab
reserved for the device. Click the Send button.
located, press the Reset button. This will set the IP address on the board.
System Setup dialog box (see Figure 3–13).
radio button.
that was established in step 4.
the Ethernet connection.
2104349 rev. AD