G4 Ex Start-Up; Pccu32 Installation And Setup; Step-By-Step Instructions; Establishing Local Communication - ABB XSeries G4 6200 User Manual

3 G4 EX start-up

The following chapter describes the steps required to get a newly installed G4 EX
system up and running. Specific information required to complete each step
(depending on equipment choice) is discussed more thoroughly in the PCCU32
Help Files.
3.1

PCCU32 installation and setup

Totalflow PCCU32 7.05.5 (or later) software is required to communicate with the
G4 EX. Previous versions of PCCU32 are not compatible.
PCCU32 software running in a laptop Windows
most capabilities for programming. The Windows environment features user
friendly Help Files and easy to follow menus. Easy to follow menus and icons step
the user through many required choices.

3.1.1 Step-by-step instructions

1) Insert the PCCU32 disk into the PC drive. The Install Program should
2) The Install Program will load followed by a Welcome message. Click the
3) A screen will display that asks for user information. Complete entering in the
4) Change the destination directory, if desired. Click the Next button.
5) Change the program folder, if desired. Click the Next button.
6) The installation process will load all the required software. If the install
7) If there is no message that asks for a restart of the computer, the installation
3.2

Establishing local communication

As discussed previously, local communication can be established in different
ways: RS-232 MMI cable, Bluetooth or USB cable. The unit can be configured for
one or the other or all. TCP/IP is available but is designed for use over a network
setup.
2104349 rev. AD
All references in older materials to absolute pressure (AP)
have been converted to static pressure (SP). This reflects
the difference of including barometric pressure during
calibration.
automatically load (assuming the Auto Insert Notification has not been
turned off).
If the Install Program does not automatically load, click on Start and then
Run.
Type the CD/DVD drive letter plus 'setup. For example: E:setup.
-
- Click the OK button.
Next button.
relevant information, and enter the serial number in the appropriate space
(the user needs to ensure that they enter both the numbers and dashes for
the serial number). Click the Next button.
program asks the user to restart the computer, the user will need to do so
before running the PCCU32 software.
is complete. Click the Finish button.
®
environment offers the user the
Page 3–1