Setup Of The G4 Ex For Bluetooth Connectivity - ABB XSeries G4 6200 User Manual

4) At this point, the user may receive a Windows
5) The installation procedure begins loading the Totalflow.inf. This should only
6) The user will need to open PCCU32.
7) With the USB cable connected, click on the Connect icon within the

3.2.3 Setup of the G4 EX for Bluetooth connectivity

The following instructions will show the user how to set up the G4 EX for Bluetooth
connectivity.
3.2.3.1
1) Plug the Bluetooth adapter into the computer. Ensure that all the relevant
2) Open PCCU32. From the PCCU32 main toolbar, select the System Setup
3) The user will need to click the Bluetooth radio button to establish that this is
4) Once this has been accomplished, the screen will populate with the relevant
5) The user may select a previous Bluetooth device in the drop-down list or
6) The user may select the preferred Totalflow Bluetooth device, or if that one
7) The user must provide the Bluetooth pairing code to automate the
2104349 rev. AD
Totalflow USB driver has not passed Windows Logo testing. If the user
wishes to use their laptop's USB port, they will need to click on Continue
Anyway, and proceed on with the installation.
take a few seconds. This will complete the Found New Hardware Wizard.
Click the Finish button. The Totalflow USB driver is now installed.
If the user sees the Found New Hardware Wizard on
subsequent connects to the meter, click the Cancel button.
PCCU32 main toolbar. The Local Connect screen displays six buttons.
From the button selections, click Entry Setup to move to the Station Setup
screen. Links within the PCCU32 tree-view will move the user to screens for
setup and daily operations.
Step-by-step instructions
drivers are installed, and the device is working properly.
icon. This will take the user to the System Setup dialog box.
the method by which they are connecting.
fields that pertain to the Bluetooth connection method. If the Bluetooth
adapter is supported by the G4 EX, the Search for Bluetooth Devices button
is activated along with a drop-down list of Bluetooth devices that have
previously been selected (see Figure 3–5).
search for a device (see Figure 3–6). If the user searches for a Bluetooth
device, the list will contain previously paired devices and not just the
devices in range.
was not found after the search, the user can initiate another search. Upon
selection, the device will be populated in the drop-down list in the System
Setup dialog box.
connection. This is typically a 4-digit authentication code set in the device
and is defaulted to 0000.
®
message that warns that the
Page 3–5