Advertisement
8. Install the tensioner spring (A) on the tensioner arm.
9. Operate all controls to make sure that the drive belt
is installed correctly and that all components are
moving correctly.
1. Install the belt cover (B) on the frame (C) and tighten
the two screws (A). (Fig. 73 )
2. Install the discharge chute.
1. Remove the 5/16'' bolts (A) and the lower ¼" bolts
(B) from the 2 sides of the frame assembly. Do not
discard the bolts. (Fig. 74 )
2. Loosen but do not remove the lower 5/16" bolts (C)
on the 2 sides of the frame assembly.
3. Remove the auger belt from the engine pulley.
4. Tilt the rear section down. The front section is tilted
forward at the same time. The bottom bolt (C) is a
hinge between the front and rear sections.
5. Put a wooden block below the hinge point to set the
product in the tilted position.
6. Move the auger belt tensioner arm and remove the
auger belt from around the arm.
1. Move the belt tensioner arm and put the auger belt
around and in the groove of the auger pulley.
Make sure that the belt is not
caught between the frame and auger
housing as you put the unit together.
2. Remove the wooden block from below the product.
3. Lift the handle to tilt the rear section up. The front
section will tilt back and pivot to attach the rear
section.
4. Make sure that the belt is put in the auger pulley
groove correctly.
5. Install the 5/16'' bolts (A), (C) and tighten (8-12
Ft.Lbs / 11-16 Nm). (Fig. 75 )
6. Install the ¼'' bolts (B) and tighten (4-6 Ft.Lbs / 5-8
Nm).
7. Install the auger belt on the engine pulley. Make sure
that the belt is put correctly around the idler pulley
and installed correctly in the engine pulley groove.
8. Operate all controls to make sure that the auger belt
is installed correctly and that all components are
moving correctly.
1. Remove the wheel pin (A) and the retainer pin (B).
2. Remove the wheel from the axle (C).(Fig. 76 )
•
Clean plastic parts with a clean and dry cloth.
•
Do not use a high pressure washer to clean the
product.
•
Do not flush water directly on the motor.
•
Use a brush to remove leaves, grass and dirt.
818 - 004 -
We, Husqvarna, SE-561 82 Huskvarna,SWEDEN,
declare under our sole responsibilty that the represented
product:
Brand
Platform / Type / Model
Batch
complies fully with the following EU directives and
regulations:
2006/42/EC
2014/30/EU
2000/14/EC; 2005/88/EC
Harmonized standards and/or technical specifications
applied are as follows: EN ISO 12100, ISO 14982, ISO
8437, ISO 3744, EN 1032
In accordance with directive 2000/14/EC, Annex V, the
declared sound values are stated in the technical data
section of this manual and in the signed EC Declaration
of Conformity.
The supplied snowthrower conforms to the example that
underwent examination.
818 - 004 -
McCulloch
ST 76EP
Serial number dating 2018 and onwards
"relating to machinery"
"relating to electromagnetic compatibility"
"relating to outdoor noise"
Advertisement
