Table of Contents
Advertisement
Warning
Locate the product in shade where proper
Do not disassemble or repair the system by
temperature remains and avoid place next
yourself since the system has high voltage
to hot object. Do not place the equipment
part inside.
or device in the place people visits a lot.
• It might cause fire, electric shock or hurt.
• It might cause fire.
The bottom surface must be moisture-free.
Position it in an open space with flat surface,
And, be cautious about any possible delicate
and do not stand it on end or diagonally.
facters, such as ungrounded extension cable,
• If it falls down, it might cause hurt.
abraded power cord, lack of safe grounding.
When any problem occurs, please consult to
an expert .
• It might cause fire or electric shock.
The cables of the power cable connectors,
The fluctuation of operation voltage must be
video signal input/output signal, Serial Port
within 10% of the regulation voltage, and the
electric outlet must be always ground.
and LAN Cable connectors on the back of the
Insulation devices, such as, hair dryers,
system can be pressed down and damaged,
irons, refrigerators, etc., must not be co-used
if it is set up too close to the wall. Maintain the
in the same outlet with this system is
distance of 15 cm between back of the main
recommended for stable power supply.
body and the wall.
• It might cause overheat, fire or electric
• It might cause fire, electric shock or hurt.
shock.
Warning
Replace the battery with the product that
If HDD is full, change the set-up to keep up
the manufacturer appointed or the equal
with recording and check again if you allow
product. Dispose the battery according to
the data to be erased.
the manufacturer's instructions.
(Refer to the "The record is not available"
• It might cause an explosion.
item in the fault report, the supplement.)
We do not bear the responsibility for the
data corruption caused by the user's lack
of care.
If the life of the HDD which stores the data
When properly connected to the HDD, the
ends, video data to be stored can be
LED status indicator in front of the system
damaged and unrecoverable. When the
blinks. Be sure that the LED status
screen is broken while playing the data
indicator blinks continuously.
stored in HDD in the midst of recording,
please request a service centeror the place
you bought it to replace the HDD promptly.
We do not bear the responsibility for the
data corruption caused by the user's lack
of care.
Advertisement
Table of Contents
