Table of Contents
Advertisement
Environment Setup
6
Network
Network
Description
Sensor for emergency
: If the sensor detects any signal it sends alarm to Remote with the recorded image during the
designated time.
Click the sensor number to configure
Emergency IP address
: Transmit emergency image or message by connecting to the assigned IP address.
Click [Emergency IP address] button and input IP address.
Transfer time
: Select the duration in sec how long it will send emergency images to SPR Smart Viewer on
connection.
If any new signal is detected while connection, image transfer time starts again.
3-6
Password
: Input required password to connect from SPR Smart Viewer p.c. (4 digit number is possible.)
[Password] : Input password required to access to DVR from SPR Smart Viewer.
[Confirm]
: Input once again to confirm.
Default value is "1234"
Viewer limite setup
: This function is set the number of Viewer allowed to connect to View.
(Max. number of connection : 1 ~ 128)
Live Stream Bandwidth
: It is availabled to set the bandwidth when transmitting the picture data by network.
(768Kbps, 1.5Mbps, 2.0Mbps, Unlimited)
Type of connection
For remote connection LAN, PSTN, ISDN, Leased Circuit can be used.
ISDN or Leased Circuit using router can be used. ISDN or PSTN can be used to connect
to DNE without router directly.
Check on "No Use" for no connection
Allow/Disallow Transfer Convert Camera
: This function allows to see the image of the camera having the 'security channel' function
from the Viewer.
: This shows the image of the security channel camera from
the Viewer.
: This does not show the image of the security channel
camera from the Viewer.
3-6
Advertisement
Table of Contents
