Samsung Real Time SHR-2041 User Manual page 88

SHR-2040/2041/2042 USER'S MANUAL
5-31
English
IP
●
Sets the IP address for the main body of SHR-2040/2041/2042 to connect with the network.
If the Connection Mode is set to Static IP, you shall type in IP yourself. If the connection mode is
Dynamic IP or ADSL(PPPoE), the IP allocated by the DHCP server or ADSL company will be
automatically displayed. In case of failure of DHCP or ADSL connection, 000.000.000.000 will be
displayed. Then, press OK to retry connection to get IP. If you continue to fail in DHCP or ADSL
connection, keep the main body of SHR-2040/2041/2042 off for a while and turn it on for retry.
Gateway
●
Sets the Gateway Address in the SHR-2040/2041/2042 main body.
Subnet Mask
●
Sets the Subnet Mask Address in the SHR-2040/2041/2042 main body.
DNS
●
Sets the DNS Address in the main body of SHR-2040/2041/2042. The default value of DNS is
168.126.63.1. Generally, you don't have to alter the DNS default but you may be hard to connect
to the network sometimes if you use DHCP or ADSL. In this case, call the network manager or
ADSL company to set up a new DNS address.
ADSL User ID
●
If the main body of SHR-2040/2041/2042 is connected with the ADSL(PPPoE) network, input
User ID subscribed to the ADSL company. You may input User ID with a Virtual keyboard as long
as 40 digits irrespective of alphabets, numbers, or symbols.
Password
●
If the main body of SHR-2040/2041/2042 is connected to the ADSL(PPPoE) network, input the
user password subscribed to the ADSL company. You may input the password with a Virtual
keyboard as long as 40 digits irrespective of alphabets, numbers, or symbols.
Caution
Caution
Be sure to set IP/Port/SubnetMask/Gateway/DNS to let Smart Viewer connect with the main
body of SHR-2040/2041/2042.
Wrong IP/Port/Gateway/SubnetMask/DNS may prevent Smart Viewer from being connected
to the main body of SHR-2040/2041/2042.
Please call the network manager or ADSL company to get each setting value.
Caution
Caution
In case of ADSL, the audio is not played in the SmartViewer.
Transfer Protocol Settings