Table of Contents
Advertisement
I I n n s s t t a a l l l l a a t t i i o o n n : : C C o o n n t t r r o o l l s s
Figure 36. Display attachments to the support arm
base plate
Adjusting the Tracer AdaptiView
Display Arm
The Tracer® AdaptiView™ display arm may become
too loose or too tight and may need adjustment. There
are three joints on the display arm that allow the
display to be positioned at a variety of heights and
angles (refer to items labeled 1 1 , 2 2 , and 3 3 in the
following figure).
Figure 37. Joint locations on the display arm
2
1
52
To adjust the tension on the display arm:
•
At each joint in the display arm, there is either a hex
bolt (1 1 and 2 2 ) or hex screw (3 3 ). Turn the hex bolt or
screw in the proper direction to increase or
decrease tension.
N N o o t t e e : : Each hex bolt or screw is labeled with
•
Joint 3 3 has a 6 mm hex screw controlling the
tension on a gas spring, which allows the Tracer®
AdaptiView™ display to tilt up and down.
•
Joints 1 1 and 2 2 are covered by a plastic cap. Remove
the plastic cap to access the screw. Adjust using a
13 mm wrench as necessary.
•
To adjust the swivel rotation tension of the Tracer®
AdaptiView™ display, adjust the screw located in
the support arm base plate, as described in the final
step in
Display," p.
to attaching the display to the support arm base.
Use a 14 mm wrench to adjust the tension.
•
To adjust the left/right swivel of the entire display
arm, use a 13 mm wrench to adjust the screw
labeled 4 4 in the preceding figure.
3
4
l l o o o o s s e e n n /t t i i g g h h t t e e n n or + + /- - indicators.
"Installing the Tracer AdaptiView
51. This adjustment must be done prior
CVHH-SVX001G-EN
Hide quick links:
Advertisement
Table of Contents
