Table of Contents
Advertisement
Installation: Controls
Figure 36. Display attachments to the support arm
base plate
Adjusting the Tracer
AdaptiView™ Display Arm
®
The Tracer
AdaptiView™ display arm may become too
loose or too tight and may need adjustment. There are
three joints on the display arm that allow the display to be
positioned at a variety of heights and angles (refer to items
labeled 1, 2, and 3 in the following figure).
Figure 37. Joint locations on the display arm
2
1
50
®
3
4
To adjust the tension on the display arm:
•
At each joint in the display arm, there is either a hex
bolt (1 and 2) or hex screw (3). Turn the hex bolt or
screw in the proper direction to increase or decrease
tension.
Note: Each hex bolt or screw is labeled with loosen/
tighten or +/- indicators.
•
Joint 3 has a 6 mm hex screw controlling the tension on
a gas spring, which allows the Tracer
display to tilt up and down.
•
Joints 1 and 2 are covered by a plastic cap. Remove
the plastic cap to access the screw. Adjust using a
13 mm wrench as necessary.
•
To adjust the swivel rotation tension of the Tracer
AdaptiView™ display, adjust the screw located in the
support arm base plate, as described in the final step in
the Installing the Tracer
section.. This adjustment must be done prior to
attaching the display to the support arm base. Use a
14 mm wrench to adjust the tension.
•
To adjust the left/right swivel of the entire display arm,
use a 13 mm wrench to adjust the screw labeled 4 in
the preceding figure.
®
AdaptiView™
®
®
AdaptiView™ Display
CDHH-SVX003C-EN
Advertisement
Table of Contents
