Advertisement
1. Place the assembled stand in the location
where the oven is going to be used.
2. Remove the side control compartment cover
and open the front control panel of a single
oven (or lower section).
3. With a tool, punch out the knock outs in the
oven bottom near each corner.
4. Set the on the stand. Center it to the frame.
NOTE: There should be approximately 1/2" of
stand visible on all sides of the unit.
5. Align the front and rear bolt holes of the oven
with the bolt holes in the stand.
6. Insert a bolt and washer, from the top down
through each of the two holes.
7. Place a nut and washer on each of the bolts
and tighten securely.
8. Replace the oven's side control compartment,
and close the front control panel.
NOTE: For single section ovens only. For
double stacked ovens step 8 will be
completed once the ovens are stacked.
1. Place a level on top of the oven. Loosen the set
screws on the side of each caster. Turn the ad
justment collar clockwise to raise and counter
clockwise to lower the oven.
2. When the oven is level, tighten the casters by
turning the two set screws on the side of each
caster assembly.
6
Advertisement
