Fresenius Medical Care 2008K Operator's Manual page 172

172
Must Run Test First The Forced Test is required before
proceeding with UF or SVS.
Need Blood Sensed
An action has been initiated that
requires that blood is sensed.
Neg. Access Flow value This message is an advisory
message that the Access Flow test
result was a negative value. A
positive value is expected.
Negative error AF value This message is an advisory
message that the Access Flow test
result was an erroneous value
New Art Limits chosen This message advises the operator
that a new set of arterial limits has
been set.
New features loaded, Advisory message when uploading
Power Off, Replace hardware key option
EEPROM
New TMP Limits Chosen This message confirms that a new set
of TMP limits have been set.
New Venous Limits? This message is a prompt for the
operator to set new venous alarm
limits.
New Ven Limits Chosen New venous alarm limits are set
No Air Detector Alarm The Prime key has been pressed. A
level detector alarm must exist for this
function to occur
Chapter 6—Alarms and Troubleshooting
2008K Hemodialysis Machine Operator's Manual Rev P
Warning To proceed with the selected operation, run the Pressure and Alarm
tests. For more information, see Chapter 2 "Testing the 2008K
hemodialysis machine."
Verify venous bloodline is in the Optical Detector.
Dialog
Message
Warning This can occur if the bloodlines were initially connected in the
reversed position. Press CONFIRM to clear the message. Check that
the bloodlines are properly connected and repeat the Access Flow
test.
Warning Press CONFIRM to clear the message. Check that the bloodlines are
properly connected and repeat the Access Flow test. Press
CONFIRM to clear the message.
Advisory Advisory only. No action is required.
Advisory Put the original calibration EEPROM in IC 20 and restart the
machine.
Advisory Advisory only. No action is required.
Advisory To set new venous alarm limits, press RESET and hold.
Advisory Advisory only. No action is required
Advisory If the venous chamber has fluid detected, the prime function will not
occur. Press RESET to start the blood pump. If a level detector
alarm occurs, then press the Prime key.