Fresenius Medical Care 2008K Operator's Manual page 161

Chapter 6—Alarms and Troubleshooting
Message Purpose of Message
E.99 (Arterial or SN Transmit error during Flash update
Blood Pump Message) while in Service Mode
EEPROM already used, Advisory message when uploading
Power Off, Replace hardware key option
EEPROM
EEPROM Missing or During startup, the machine cannot
Reading Error properly read the EEPROM memory
chip
Emptying The blue dialysate line connector is
on the shunt with door closed, the red
dialysate line connector remains on
the dialyzer in order to drain the
dialysate compartment.
Emptying Stopped When air is sensed, emptying will
stop.
Emptying too long The dialyzer empty program has
exceeded its maximum limit.
Error Reading Flash Electronic Self Test
Fail * 9 Volt Battery 9V Power Failure Battery test has
failed.
Fail *Actuator Arterial Arterial Pressure test has failed.
High
Fail *Actuator Arterial
Low
Fail * Actuator Conductivity test has failed.
Conductivity High
Fail * Actuator
Conductivity Low
161
Type Action Required
Alarm If this message occurs in dialysis mode, return the blood to the
patient if during a treatment. Take the blood pump module out of
service and alert a qualified service technician.
Advisory Put in a new hardware key or calibration EEPROM in IC 20 and
power up.
Opening Turn the machine off and try to power up again. If the message
Screen repeats, take the machine out of service and alert a qualified service
Message technician.
Warning If this message occurs when the dialyzer is not being emptied, take
the machine out of service and alert a qualified service technician.
Warning Connect the red dialyzer return line to the shunt. If the warning is
repeated, take the machine out of service and alert a qualified service
technician.
Alarm If blood is not sensed, return the dialyzer supply and return lines to
the shunt and close the shunt door to terminate the program. If the
machine was in dialysis (blood sensed), turn machine power off and
back on to clear the program.
Alarm Turn machine power off and back on. If alarm is not cleared, take the
machine out of service and alert a qualified service technician.
Test Replace Battery
Message
Test Rerun test, if failure repeats, remove from service and alert a
Message qualified service technician.
Test Rerun test, if failure repeats, remove from service and alert a
Message qualified service technician.
2008K Hemodialysis Machine Operator's Manual Rev P