Table of Contents
Advertisement
6.4 Printer parameters
This printer allows the coniguration of the parameters listed in the following table.
The parameters marked with the symbol
Settings remain active even after the printer has been turned off and they are stored in non-volatile memory.
PRINTER EMULATION
RS232 BAUD RATE
RS232 DATA LENGTH
RS232 PARITY
RS232 HANDSHAKING
BUSY CONDITION
D
are the default values.
Available emulations for the device:
VKP80III
D
VKP80II
Communication speed of the serial interface:
D
115200
38400
57600
19200
NOTE: Parameter valid only with serial interface.
Number of bit used for characters encoding:
7 bits/car
8 bits/car
D
NOTE: Parameter valid only with serial interface.
Bit for the parity control of the serial interface:
None
D
= parity bit omitted
Even =
even value for parity bit
Odd =
odd value for parity bit
NOTE: Parameter valid only with serial interface.
Handshaking:
XON/XOFF =
software handshaking
Hardware
D
=
hardware handshaking (CTS/RTS)
NOTES:
Parameter valid only with serial interface.
When the receive buffer is full, if handshaking is set to XON/XOFF, the printer sends the XOFF (0x13) on the
serial port. When the receive buffer has cleared once again, if handshaking is set to XON/XOFF, the printer
sends the XON (0x11) on the serial port.
Activation mode for Busy signal:
OffLine/ RXFull = Busy signal is activated when the printer is both in OffLine status and
the buffer is full
D
RXFull
=
Busy signal is activated when the buffer is full
NOTE: Parameter valid only with serial interface.
9600
51
Advertisement
Table of Contents
