Printer Parameters - Custom Audio Electronics TG2480H User Manual

5.4 Printer parameters

This printer allows the coniguration of the parameters listed in the following table.
The parameters marked with the symbol
Settings remain active even after the printer has been turned off and they are stored in non-volatile memory.
BAUD RATE
DATA LENGTH
PARITY
HANDSHAKING
BUSY CONDITION
AUTOFEED
50
D are the default values.
Communication speed of the serial interface:
D
115200 19200
57600 9600
38400 4800
NOTE: Parameter valid only with serial interface.
Number of bit used for characters encoding:
7 bits/car
D
8 bits/car
NOTE: Parameter valid only with serial interface.
Bit for the parity control of the serial interface:
D
None = parity bit omitted
Even = even value for parity bit
Odd = odd value for parity bit
NOTE: Parameter valid only with serial interface.
Handshaking:
= software handshaking
D
XON/XOFF
Hardware = hardware handshaking (CTS/RTS)
NOTES:
Parameter valid only with serial interface.
When the receive buffer is full, if handshaking is set to XON/XOFF, the printer sends the XOFF (0x13) on the
serial port. When the receive buffer has cleared once again, if handshaking is set to XON/XOFF, the printer
sends the XON (0x11) on the serial port.
Activation mode for Busy signal:
OffLine/ RXFull = Busy signal is activated when the printer is both in OffLine status and
the buffer is full
RXFull = Busy signal is activated when the buffer is full
D
NOTE: Parameter valid only with serial interface.
Setting of the Carriage Return character:
CR disabled = Carriage Return disabled
D
CR enabled = Carriage Return enabled
2400
1200