Table of Contents
Advertisement
7.3 Upgrade irmware
WARNING: During communication between PC and
device for the irmware update it is strictly forbidden to
disconnect the communication cable or to remove the
power supply of the devices not to endanger the proper
functioning of the machine.
NOTES:
The latest irmware of the device is available in the down-
load area of the web site www.custom.biz
Install on the PC used for printer upgrading the UPG-
CEPRN software available in the download area of the
web site www.custom.biz.
Update via serial interface
Proceed as follows:
1. Write down the product code (14 digits) printed on the
product label (see paragraph 3.4).
2. Go to the web site www.custom.biz and download the
appropriate irmware release from the DOWNLOAD
area.
3. Print the SETUP report (see chapter 6).
4. Switch OFF the device.
5. Connect the device to the PC using a serial cable (see
paragraph 4.2).
6. Switch ON the device.
7. Launch the software UPGCEPRN.
8. Select the update ile .PSW location:
Firmware rel.:
None
Hardware rel.:
None
PSW Version :
None
File [*.cfg] :
None
File (*.psw):
Select (*.psw):
Data flush status...
Upgrade status:
No upgrade thread active...
62
Printer type:
None
Select port:
None
Begin upgrade
Port config:
Communication port not init
9. Select the serial communication port (ex. COM1):
Select the system communication port
Available port
COM1
COM2
Firmware rel.:
None
COM3
Hardware rel.:
None
COM4
COM5
PSW Version :
None
COM6
File [*.cfg] :
None
File (*.psw):
C:\<device>.PSW
Select (*.psw):
Data flush status...
Upgrade status:
No upgrade thread active...
10. Detecting and setting of the parameters necessary for
serial communication are performed automatically and
then updating begins.
11. After a few minutes a message on the screen warns
that the update is completed.
Upgrade OK
Upgrade succesfully completed.
12. Print a new SETUP report to verify the new irmware
release (see chapter 6).
OK
Printer type:
None
Cancel
Select port:
None
Selected port
COM1
Begin upgrade
Port config:
Communication port not init
OK
Advertisement
Table of Contents
