1-4-5. DC Fan (for Lamp)
1. Remove the panel (U7) block assembly. (Refer to Section 1-3-2.)
2. Remove the panel (U2) block assembly. (Refer to Section 1-3-3.)
3. Remove the panel (U6). (Refer to Section 1-3-5.)
4. Remove the two screws, then remove the lamp base cover.
5. Disconnect the four harnesses from the connectors (CN7, CN8, CN10 and CN12) on the DST-27
board.
6. Remove the eight screws, then remove the four lamp fan block assemblies.
PSW4 x 10
DST-27 board
DST-27 board (Side A)
CN7
CN10
SRX-R320
Lamp base cover
PSW4 x 10
CN8
CN12
Fig. 1-4-5a
Lamp fan block assemblies
1-25 (E)