Noise Filter (Rsan-2010/Rsan-2030) - Sony SRX-R320 Service Manual

1-4-2. Noise Filter (RSAN-2010/RSAN-2030)

1. Remove the panel (U7) block assembly. (Refer to Section 1-3-2.)
2. Remove the panel (U2) block assembly. (Refer to Section 1-3-3.)
3. Remove the panel (U3). (Refer to Section 1-3-4.)
4. Open the two covers of the noise fi lter (RSAN-2010) in the direction of the arrow.
5. Loosen the fi ve supplied screws, then remove the fi ve harnesses.
6. Remove the two screws (PSW4 x 10), then remove the noise fi lter (RSAN-2010).
7. Open the two covers of the noise fi lter (RSAN-2030) in the direction of the arrow.
8. Loosen the fi ve supplied screws, then remove the fi ve harnesses.
9. Remove the two screws (PSW4 x 10), then remove the noise fi lter (RSAN-2030).
10. To install, reverse the removal procedure.
SRX-R320
Covers
Harnesses
Supplied screws
Noise filter
(RSAN-2030)
Harnesses
Covers
Supplied screws
Fig. 1-4-2
PSW
4 x 10
Harnesses
PSW
4 x 10
Covers
Harnesses
PSW
4 x 10
Supplied screws
Noise filter
(RSAN-2010)
PSW
4 x 10
PSW
4 x 10
1-21 (E)