Install The Dongle On The Boat (Optional); Determine The Mounting Location - Humminbird AS RC Operation Manual

I
NSTALL THE
The dongle is designed to mount on any flat, level surface on your boat using the screws provided
in the installation kit. Use the following instructions to install the dongle on your boat.
Installing the dongle on the boat is optional and is only applicable to the remote with dongle (AS RC
1) accessory for control heads without Bluetooth technology. To skip this procedure, proceed to
Getting Started.
SUPPLIES: In addition to the hardware supplied with your installation kit, you will need a powered
hand drill, 7/64" drill bit, various Phillips screwdrivers, safety goggles, dust mask, level, and a pencil.

1 | Determine the Mounting Location

Prior to installation, you must first determine where to mount the dongle with the following
requirements:
• Interference: The mounting location must provide adequate distance between the dongle
and any of the following materials:
metal surfaces
compass or other magnetic equipment
electric motors or any equipment that may cause electronic interference.
• Stability: The mounting location should be protected from waves, shock, vibration, and water.
• Surface Space: The mounting location should allow adequate room around the dongle, so
the top and sides of the dongle do not touch other equipment or surfaces.
1. Use a level to locate a suitable, flat area to mount the dongle.
2. Test route all appropriate cables to the dongle (AS GPS NMEA, GPS Receiver) based on the
configuration for your control head (see Connect Cables).
NOTE: To purchase accessory cables, visit our Web site at humminbird.com or call
Humminbird Customer Service.
NOTE: Extension cables may affect performance.
Install the Dongle on the Boat
D
ONGLE ON THE
B
OAT (
OPTIONAL
11
)