Confirm The Connection - Humminbird AS RC Operation Manual

Connecting the Dongle to the NMEA 0183 (1-2) Port on the ONIX Control Head
HELIX
1. Connect the dongle cable connector to the Communications (COM) port on the back of the
control head.
NOTE: The location of the Communications (COM) port will vary based on your
control head model. See your control head installation guide for more details.

2 | Confirm the Connection

Use the following instructions to confirm wireless connection on the control head. Also, see the
section Getting Started: Confirm Connection on the Control Head.
1. Power on the control head.
2. Confirm the wireless remote and dongle connection:
ONIX: Select Settings > Network > Network Info. Confirm the dongle and wireless remote are
listed under This Unit.
HELIX: Press the VIEW key until the Accessory Test View is displayed. Confirm the dongle
and wireless remote are listed under Accessory Test.
NOTE: If the Accessory Test View is not displayed in the view rotation, confirm it is
set to visible in the menu system.
Installation Preparation
Connecting the Dongle to the COM Port
on the HELIX Series Control Head
COM port
9
screw nut
AS GPS NMEA cable