5. Mounting Installation
This section describes how to install the industrial device and make
connections to it. Please read the following sections and perform the
procedures in the order being presented.
In the installation steps below, this manual uses PLANET
IGS-801 8-port Industrial Gigabit Switch as an example.
The steps for PLANET Industrial Slim-type Switch, Indus-
trial Media/Serial Converter and Industrial PoE devices
Note
are similar.
5.1 DIN-rail Mounting
The DIN-rail bracket is already screwed on the industrial device. Refer
to the following steps on how to install the industrial device:
Step 1: Lightly place the upper bracket found on the back of the
IPOE-171 into DIN rail and push the unit down till the lower
bracket is locked into the track.
Figure 10: Mounting industrial device on DIN rail.
2
17