Adjusting The Volume Balance; Outputting Aux-Bus Audio - Roland V-60HD Owner's Manual

Adjusting the Volume Balance

This adjusts the volume balance of input and the volume level for
master out.
1.
Adjust the [MASTER OUTPUT] knob to a position near "0 dB."
2.
While monitoring the audio via speakers or headphones,
adjust the volume balance for the respective inputs.
Raise the volume level of audio you want to make more prominent,
for example, an emcee microphone, and lower the volume level for
other audio.
When no audio is input, and for audio that is unused, lower the
volume level to minimum (-INF).
AUDIO IN 1–5/6
Use the AUDIO INPUT LEVEL knob to adjust the volume level.
SDI IN 1–4, HDMI IN 5 and 6
Select the [MENU] button0"AUDIO INPUT"0"SDI IN 1–4" or
"HDMI IN 5–6"0"INPUT LEVEL, " then use the [VALUE] knob to
adjust the volume level.
3.
Use the [MASTER OUTPUT] knob to adjust the volume level
for master out.
* If the volume level of speaker output is not suitable even after
adjustment so that -20 to -6 light up, adjust the volume for the
speakers or the amplifier. Using the [MASTER OUTPUT] knob
to carry out further adjustment might result in distortion or
degradation of sound quality.
MEMO
You can output a test tone, which is useful for adjusting the
volume level. Select the [MENU] button0"SYSTEM"0set
"TEST TONE" to "-20dB@1kHz, " "-10 dB@1kHz, " or "0dB@1kHz. "
A level at which indicators "-20"
through "-6" light up is appropriate.
Excessive
Suitable
Insufficient
(dB)

Outputting AUX-bus Audio

You can output just AUX-bus audio from the AUDIO OUT jacks
(XLR and RCA) and the PHONES jack.
What's AUX-bus audio?
Video and audio on video input channels selected using the
AUX/MEMORY buttons is sent to the AUX bus (p. 18).
When you assign the AUX bus to an audio output connector,
only the SDI or HDMI audio sent to the AUX bus is output.
1.
Select the [MENU] button0"AUDIO OUTPUT"0"OUTPUT
ASSIGN"0"AUDIO OUT (XLR)," "AUDIO OUT (RCA)," or
"PHONES OUT."
2.
Use the [VALUE] knob to set this to "AUX."
Value Explanation
This groups together all input audio and
MASTER OUTPUT
outputs it (master out).
AUX This outputs only the audio on the AUX bus.
3.
Press the [VALUE] knob to apply the setting.
4.
Press the [MENU] button to quit the menu.
MEMO
5 To adjust the volume level of audio on the AUX bus, select the
[MENU] button0"AUDIO OUTPUT"0"AUX"0adjust "AUX
LEVEL. "
5 For the SDI OUT and HDMI OUT connectors, changing the
assigned video bus makes the output audio also change in
tandem with it.
For details, refer to "Changing Output Bus Assignments" (p. 15).
* The audio of the MULTI-VIEW connector is fixed at master
out and cannot be changed.
Audio Operations
25