Power Cords; Cautions And Regulatory Compliance Statements For Nebs; Nebs Compliance Statements - IBM TS2900 Setup, Operator, And Service Manual

Power cords

For your safety, IBM provides a power cord with a grounded attachment plug to use with this IBM
product. To avoid electrical shock, always use the power cord and plug with a properly grounded outlet.
For your safety, IBM provides a power cord with a grounded attachment plug to use with this
IBM product. To avoid electrical shock, always use the power cord and plug with a properly
grounded outlet.
IBM power cords that are used in the United States and Canada are listed by Underwriter's
Laboratories (UL) and certified by the Canadian Standards Association (CSA).
For units intended to be operated at 115 volts: Use a UL-listed and CSA-certified cord set
consisting of a minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 15 feet
in length and a parallel blade, grounding-type attachment plug rated 15 amperes, 125 volts.
For units intended to be operated at 230 volts (US use): Use a UL-listed and CSA-certified cord set
consisting of a minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 15 feet
in length and a tandem blade, grounding-type attachment plug rated 15 amperes, 250 volts.
For units intended to be operated at 230 volts (outside the US): Use a cord set with a
grounding-type attachment plug. The cord set must have the appropriate safety approvals for the
country in which the equipment are installed.
IBM power cords for a specific country or region are available only in that country or region.

Cautions and regulatory compliance statements for NEBS

This library is NEBS certified. This section includes the cautions and regulatory compliance statements for
the Network Equipment-Building System (NEBS) certification from the Telcordia Electromagnetic
Compatibility and Electrical Safety - Generic Criteria for Network Telecommunications Equipment (A
Module of LSSGR, FR-64; TSGR, FR-440; and NEBSFR, FR-2063) Telcordia Technologies Generic
Requirements, GR-1089-CORE, Issue 4, June 2006.
Table 2. NEBS Compliance Statements
CAUTION:
To comply with the Telcordia GR-1089-CORE standard for electromagnetic compatibility and safety, for Ethernet
RJ-45 ports, use only shielded Ethernet cables that are grounded on both ends. In a NEBS installation, all
Ethernet ports are limited to intra-building wiring.
CAUTION:
The intra-building ports of the equipment or subassembly are only suitable for connection to intra-building or
unexposed wiring or cabling. The intra-building ports of the equipment or subassembly must NOT be
metallically connected to interfaces that connect to the OSP or its wiring. These interfaces are designed for use
only as intra-building interfaces (Type 2 or Type 4 ports as described in GR-1089-CORE, Issue 4), and require
isolation from the exposed OSP cabling. The addition of primary protectors is not sufficient protection in order
to connect these interfaces metallically to OSP wiring.
An external Surge Protective Device (SPD) is not required for operating this library.
xxii
IBM TS2900 Tape Autoloader: Setup, Operator, and Service Guide Machine Type 3572